Pergola curtain track from AKON lets you easily slide your outdoor curtains open and closed on steel roller hooks, without sagging rods or snagging rings. The 16 gauge galvanized steel track mounts to wood, aluminum or steel pergolas, does not rust and comes with a lifetime warranty. Most orders ship within 3 to 4 days, and every track kit comes with enough roller hooks.
Material
Holds
Warranty
Ships In
Choose Your Pergola Track Mount
Ceiling Mount
A ceiling mount screws flush into the bottom of a wood or aluminum beam, giving you a neat finish. It is the most popular way to install track on a pergola.
Wall Mount
A wall mount attaches brackets to the front of a header beam or post, allowing the track to run along its side. It's a good choice when there is not enough space under the beam or when the beam is not even.
Chain or Cable Mount
The track is hung on galvanized chain or cable below a high or peaked roof. It’s a good fit for pavilions and long spans between posts.
Threaded Rod Mount
Steel rods are used to lower the track to door height when the roof is too high or has a louvered design. We provide the track fittings, but you will need to buy the rods from a local supplier.
I-Beam Mount
An I-beam mount attaches directly to the bottom flange of a steel beam without drilling. The clamp can swivel, and a set screw locks it in place.
Free-Standing Track
You do not need a pergola because the track is held by steel posts on flat base plates. Use it for a privacy screen on a patio or deck.
Curtain Track vs. Rod vs. Cable for a Pergola
Curtain Track
Curtain Rod
Wire Cable
| Curtain Track | Curtain Rod | Wire Cable | |
|---|---|---|---|
| Glide | Smooth; wheels roll inside the rail | Rings drag and catch on brackets | Clips slide, but snag at supports |
| Long spans | Any length; supports every 5 ft keep it straight | Needs center brackets on long runs | Sags in the middle unless kept tight |
| Corners | Yes, with 24 in. radius corners | No | No |
| Heavy curtains | Up to 125 lb. per hook | Depends on the rod | Light to medium panels |
| Best for | Curtains opened and closed often | Short, simple openings | Light curtains on a budget |
What Comes With Your Pergola Track
Galvanized Steel Track
The 16 gauge pergola track is 1.45 in. wide and 1.25 in. tall, and the sections splice together to give you any length you want. The sections cost between $4.99 (2 ft) and $20.99 (8 ft).
Roller Hooks
Every kit comes with roller hooks, one for every foot of track plus two extra hooks. Nylon wheels support up to 40 lb., double steel wheels hold up to 75 lb., and four-wheel steel hooks can handle up to 125 lb. You can check out all our curtain hangers.
90 Degree Radius Corners
The 24 in. 90 degree radius corner lets you move the curtain smoothly around the corner of your pergola without stopping. Each corner costs $68.50.
Mounting Hardware
Mounting supports are placed every 5 ft, and you can use them for ceiling, wall, chain, threaded rod or I-beam installation. Set screws secure every joint to keep the track firm. You can check out all our curtain track components.
How To Measure Your Pergola for Curtain Track
Measure the track length post to post along each side where the curtain will run. If one curtain needs to wrap a corner, let us know and we will add a radius corner.
To get the mounting height, measure from where the track will mount down to the patio floor. When you order curtains with the track, we subtract 3 in. from that measurement so the curtain hangs just above the ground and does not drag. Check out our curtain height sheet to see how it works.
To choose the mount type, look at what the track will hang from: the bottom of a beam, the face of a beam, a tall roof or a steel beam. Select the matching mount above.
You need one hook per grommet, and the grommets should be spaced about 12 in. apart along the top of the curtain. Your kit comes with one hook per foot of track plus two extra, which is enough hooks.
Common Questions
Can you add curtains to a pergola?
Yes, you can add curtains to a pergola. Mount a curtain track underneath or beside the pergola beams, and hang grommeted outdoor curtains from roller hooks. Most wood pergolas use a ceiling mount screwed to the underside of the beams, while steel pergolas can use I-beam clamps that hold everything in place without drilling.
What is the best way to hang outdoor curtains on a patio?
The best way to hang outdoor curtains on a patio is to use a steel curtain track. The roller hooks slide smoothly inside the rail, so you can open heavy outdoor curtains with one hand, and unlike a rod or cable, a long run won’t sag.
How do I keep my outdoor patio curtains from blowing in the wind?
To keep them from blowing in the wind, hang your outdoor patio curtains from a track, where the hooks glide inside the rail and can’t pull off, and control the bottom of the curtains. When the curtains are open, tie them back to a post, and choose a heavier curtain material for the windy side.
How do you hang outdoor curtains without drilling holes?
To hang outdoor curtains without drilling holes, use a free-standing curtain track. It stands on steel base plates, so you do not need to attach anything to your house or pergola. For a steel pergola, I-beam clamps attach directly to the beam’s lower edge, so you can install the track without drilling any holes.
Will pergola curtain track rust?
No, pergola curtain track does not rust. It is made from 16 gauge hot dipped galvanized steel built to withstand outdoor conditions, including wash bays, and it comes with a lifetime warranty. It arrives with a plain galvanized finish, but you can spray paint it when it arrives to match your pergola.
How much weight can pergola curtain track hold?
The weight pergola curtain track can hold depends on the roller hook: nylon wheels hold up to 40 lb., double steel wheels about 75 lb. and four-wheel steel hooks up to 125 lb. each. With a hook every 12 in., even heavy vinyl outdoor curtains stay well under those limits.
Specs, Drawings and Installation Guides
What is the pergola curtain track constructed from?
The pergola curtain tracks are made from galvanized steel. They offer good protection against rust, are very suitable for oceanside use and can withstand harsh conditions, including chemical wash-down applications.
How thick is the curtain track?
The standard curtain track is 16 gauge thick, which is equal to 0.0635 inches. Currently, we do not supply 12 gauge thickness (0.1084 inches) because it is more than you need for hanging curtains.
Build Yours Now
Related Products
Industrial Curtain Track
Outdoor Curtain Track
Curtain Track Components
